| Model： |
|
Model
|
Determination of Hole Number
|
Connection Dental mouth diameter
|
For fluid
|
|
SV-318
|
3Hole
|
Rc1/8
|
Petroleum oil for general dynamic
|
|
SV-314
|
Rc1/4
|
|
SV-618
|
6Hole
|
Rc1/8
|
|
SV-614
|
Rc1/4
|
|
F-SV-318
|
3Hole
|
Rc1/8
|
Phosphate salts to move oil
|
|
F-SV-314
|
Rc1/4
|
|
F-SV-618
|
6Hole
|
Rc1/8
|
|
F-SV-614
|
Rc1/4
|
|
Specialty：
|
| ＊ |
The pressure gauge switching valve can be measured with a pressure gauge up to 1 ~ 6 of the loop pressure。 |
| ＊ |
The use of a pressure gauge to complete the job, so greatly reduced the pressure gauge and pressure gauge installed on the control panel with the hole in the processing, can dramatically reduce the cost of hydraulic equipment。 |
| ＊ |
As is the rotary switching valve, as long as the loop number will handle the arrow aligned pressure can be measured。 |
| ＊ |
Outside in the determination period will handle aligned "ALL CLOSE" position, it will discharge from the discharge of residual pressure within the pressure gauge, pressure gauge when the instruction pointer constant "0" position, thereby enhancing the precision pressure gauge, durable sex。 |
|
|
Specification：
|
|
Maximum pressure
|
21MPa
|
|
Pressure-resistant
|
38MPa
|
|
Installation
|
Panel Mount
|
|
Back pressure from the discharge port to allow
|
＜Set the conditions＞
For mobile oil: ISO VG32 oil temperature ： 45±5℃
|
7MPa ：20cm3／minThe following
14MPa ：30cm3／minThe following
21MPa ：40cm3／minThe following |
|
Back pressure from the discharge port to allow
|
1.5MPaThe following
|
| Net weight |
2500g |
|
| Caution： |
| ＊ |
Switching valve for the discharge piping, the discharge to make the symmetrical position to exert the same pressure to connect。 |
| ＊ |
The valve seal structure and the main bore diameter reel with a metal seal gap 10μ way around. If dirt, etc. attached to the handle will send Shibuya, turn no case, so please pay attention to the situation for moving dirty oil。 |
| ＊ |
Washing piping, please be careful not to dirty the washing oil into the valve。 |
| ＊ |
Please change periodically the implementation of the operation handle。 |
| ＊ |
Please discharge piping will be raised to a position above the valve and then installed on the discharge. This phenomenon is difficult to produce hydraulic adhesion。 |
| ＊ |
Discharge to maintain the internal pressure, the valve handle will be re-Yi, illegal turn. Be sure to install the vent pipe discharge。 |
|
| Use Cases： |
| ＊ |
Plastic injection molding machine, rubber injection molding machine |
| ＊ |
Hydraulic Press (powders, ceramics, rubber stamping） |
| ＊ |
Machine tools (large-scale machine tools, special purpose machine, NC Sawing Machine） |
| ＊ |
Hydraulic unit (industrial, machine tools, ships, valve stations） |
|
|
|
|
|
|
|
US-series